Honeywell Port Devices Driver

Posted on by

The DEM protocol driver is designed to provide a tightly integrated communications interface between other protocols of the ProLinx platform and the Honeywell DE instruments. Compatible DE devices include a large array of field devices including pressure, temperature, metering, and many other instruments. 1.1 DEM Driver Overview. Devices), you will have to change this USB class in order to connect. See USB Connection on page 13 for further information. Connect the USB cable to the printer and to the USB port on the host system. Power up your printer. Your host computer should recognize the printer and begin adding the device driver. Install the Drivers of your Honeywell Xenon 1900. Before using the scanner, some drivers need to be installed on the computer. Make sure the barcode scanner is not plugged in. Download the USB Serial Emulation Mode Drivers (Virtual COM Port Drivers). Click here to Download; Once the driver has been downloaded. Unzip the content in a new folder.

Honeywell Port Devices Driver Device

-->

For most devices, the Ports device setup class and the Serial function driver provide the functionality required to operate serial ports and COM ports. To install serial ports and COM ports using these system-supplied components, do the following:

  • Provide an INF file that specifies the Ports device setup class and the Serial function driver as the service for the port.

  • To configure a serial port as COM port, comply with the requirements that are defined in Configuration of COM Ports.

For more information about installing serial ports and COM ports using the Ports device setup class and the Serial function driver, see the following topics:

Honeywell Port Devices Driver Updater

If you do a custom installation of a COM port, you must comply with the COM port requirements that are defined in Configuration of COM Ports.

Click here to download.Honeywell

Honeywell Port Devices Drivers

Honeywell

New Features:
• Event logging for manual request of door energize, de-energize, and pulse has been added.

Honeywell Port Devices Driver

List of Issues Resolved (03.06.25 Production Release):
• Outputs will energize when you swipe a card after the time zone expires on a group.
• Supervisor Mode toggles back on at Midnight with NetAXS 4-door.
• Event logging needed for Manual request of door energize and pulse
• TZ toggle time zone set Default Time Zone (24x7), the output will energize before swiping valid card to toggle TZ.
• The state of outputs do not in accord with the group when change the toggle manually
• Reader LED does not follow the state of the output relay controlling the door.
• A manual Pulse will De-energize a manual Energized output.
• Reader LED randomly not following the output controlling the door when the output is in a time zone.
• Pulse Command will cause output to Energize on a Time Zone when using First Valid Card Rule.

• Reader LED is not following the Output State when the Output Toggle during Time Zone feature is enabled
• Pulse will cause Group to energize when Group is in a time zone.